|
Water-powder
mixing pump makes use of high-speed rotating wing
wheel to sufficiently mix materials and fluids in
order to receive required finished products, the
max temperature absorbed by this equipment is 80∩，
especially suitable for producing remanufacturing
milk, besides, it can be used to produce juice and
other beverages, so that it is one of necessary
equipments in foodstuff and beverage industries.
1、Before using, pay attention whether the
sealing parts are properly assembled, whether the
coupling parts are tight and reliable, whether the
rotation direction of wing wheel is clockwise, furthermore,
in order to ensure sanitary requirements of food,
disinfect the machine with steam before using, make
sure that everything is okey before using.
2、 Using notice: The upper screw
thread pipe （Rd58?1/6） connecting to pump cover
is fluid inlet, the liquid after mixing flows out
from the lower nozzle （Rd58?1/6）, the two trapeziform
rubber pipe tie-in at the lower part of pump are
inlet and outlet pipes for cold water, specially
for cooling down mechanical sealing.
This pump is very convenient
to disassemble, as long as loosening the clamp could
the inlet hopper and pump cover come away, as long
as unscrewing the four nuts could the pump cover
be opened, as long as loosening the locknut (this
nut is left turning, the clockwise direction is
loosening) on the principal axis and taking wing
wheel away could the mechanical sealing parts be
seen. Besides, there are two seals between principal
axis and motor, if there is leakage, examine whether
the sealing parts are damaged immediately, replace
them if necessary. The mechanical sealing parts
can be used after rubbing.
3、Disassemble and clean immediately
after using to prevent dirt of fluid material from
accumulating. Disassemble the wing wheel to carry
out general cleaning. At first, let hot water pass
through it, second, disassemble and clean out, third,
assemble one after another, the on the machine
frame should not be blocked, or the sealing washer
will be invalid and the liquid will overflow to
motor, that is to say, it may be burnt.
４、When using and cleaning, the outer crust of motor
should not be disassembled to prevent motor from
being damaged because of water entering.
|
Mix
the pump